Joined in 2023 
82 
63 About this deal
It’s a standard mod when dealing with Longshots and if you’ve seen a Nerf Longshot mod guide before, I’m sure you’re at least somewhat familiar with how to do it. What you want to do is refit the new reinforced OMW bolt sled back into the same position the original sled was.
This is our standard performance o-ring for the Longshot and is the same o-ring that ships with the stage 2 kit. I’ll be skipping this step, as my Elite Longshot didn’t have any air holes in the breech whatsoever. While holding the spring down, you have to grab the new plunger head and screw it onto the top of the plunger rod. These two Orange Mod Works mod kits have a replacement piece for almost every single component in the Longshot. If you read my review of the blaster, you would know that the guts of this blasterwere still circa 2006 N-Strike internals.It also comes with a new O-Ring, trigger spring, plunger screw, and white lithium grease for lubrication.
The Stage 2 kit comes with an all metal trigger, an entire new bolt sled, a new plunger rod and plunger head. I started this site after I became a dad - to learn about all of the new blasters and review and catalogue them - because I wanted to share one of my favorite childhood pastimes with my son -- and now, I fell back in love with the hobby!
If you’ve been following along with the Nerf Longshot mod guide, this is what the Longshot should look like by the time you’re done removing everything. We ship internationally to a lot of countries such as Australia, Singapore, United States and Europe etc.
You’ll also want to add in the new metal trigger, trigger spring, catch, and catch spring into the blaster now. Make sure you fold out the Longshot’s built-in bipod legs, because there are a few hidden screws underneath them. Depending on which Longshot you have, you may need hot glue or epoxy putty to seal up the air release hole on the breech.It’s a bit longer than the plunger rod, so you’ll have to compress the spring and hold it down while you complete the next step.
The other side is rough and is meant to friction fit and hold it firmly in place when fully installed. If you’ve been following along with my Nerf Longshot Mod Guide, you should have installed both Orange Mod Works Mod Kits. It gives you a slightly heavier trigger pull which can be a good thing if you are running a heavily modded Longshot without a trigger guard. I opted to remove the bipod legs, but that isn’t a necessary procedure for the Nerf Longshot mod guide.All audio, visual and textual content on this site (including all names, characters, images, trademarks and logos) are protected by trademarks, copyrights and other Intellectual Property rights owned by Hasbro or its subsidiaries, licensors, licensees, suppliers and accounts. I’ve had great experiences with their products in the past and so I had no problems using them again. Although this Nerf Longshot Mod Guide is for the more recent, Elite blue colored Longshot, you can use these kits with all existing models of the Nerf Longshot CS-6. In addition to aPhillips head screwdriver(or two), you’ll also need a claw hammer, a pair of needle nose pliers, and optionally, a Dremel.
Great Deal 
New Comment